Robopac ROTOPLAT 108-308-508-708, Руководство по эксплуатации и обслуживанию

Страница: 76 / 121

ENG INFORMATION ABOUT THE USE
76
6. INFORMATION ABOUT THE USE
6.1. RECOMMENDATIONS FOR OPERATION AND USE
- When using the machine for the first time, the operator must read the manual and identify the control functions
and simulate some operations, especially machine start and stop.
- Make sure that all safety devices are properly installed and efficient.
- Only carry out the operations foreseen by the Manufacturer and do not tamper with any device to obtain
different performance levels.
- Daily, before each use of the machine, check that it stops by pressing the emergency button to trigger the
bumper.
Caution - warning
Bumper can be triggered by placing an obstacle in front of the machine at a distance of approximately
20 cm.
Important
The frequency of the accidents derived from machine use depends on many factors that cannot always
be foreseen and controlled.
Some accidents may be caused by unpredictable environmental factors, others are mainly due to
users’ behaviours.
On first use, and if required, in addition to being authorised and appropriately informed, the personnel
must simulate some manoeuvres to identify the main controls and functions.
Only carry out the operations foreseen by the Manufacturer and do not tamper with any device to
obtain different performance levels.
Make sure the safety devices are properly installed and efficient before use.
Users, besides complying with these requirements, must apply all the safety regulations and carefully
read the descriptions of the controls and commissioning.