Alarm Interface Manual
ISO 9000-2000 Approved
Specifications:
Dimensions: 170 x 95 x 29 mm
Weight: 180 gsm
Current Consumption: 10 m A
Required Power Supply: +12V D.C.
•
The Alarm Interface(AI)can, supervise and monitor
up to four Roboguards, with individual intruder
detected, tamper and status LED’s.
•
The Alarm Interface has six relay switches all
N/O and N/C
RED Status LED FLASHING (Automatic battery
and radio strength test)
The auto-test routine is very important. The
Roboguard sends an ‘auto-test’ radio signal to the
keypad every 20 minutes. Should a guard fail to
report in, the
AI
will indicate this by flashing the
red status LED. To establish which Roboguard is
reporting the status condition and to reset the
status LED you must do the following.
NOTE: Status indicates potential
communication problems that may be due to
bad radio reception, battery problems or faulty
TX or CPU PIRs.
1.
Press and release the status button (Status
LED
“ON”, AI
is now in Status condition
display mode)
2.
The zone LED for the Roboguard that has
reported Status will be on guard.
3.
Press and release all
ON
LED’s so only the
red Status LED is
“ON”
.
4.
Press and release the Status button (LED off)
or do nothing as the keypad will time out and
exit automatically.
5.
Determine what is causing the Roboguard to
fail auto-test and correct the problem.
THIS 24HR ZONE IS THE HEART BEAT
OF THE PROGRAMMED GUARDS AND
WILL REMAIN OPEN CIRCUIT, UNTIL
THE PROBLEM HAS BEEN SOLVED.
INSTALLERS DETAILS
Name:
Company:
Contact details:
Cell:
Date of installation:
NOTES
