MANUAL DE INSTRUCCIONES
INSTRUCTION MANUAL
Avda. de Las Retamas 5. 45950 Casarrubios del Monte (Toledo) España
Tel: +34 91 616 50 20 Email: [email protected]
www.roblan.com
LED ICE IP20
NOTES
The product should be installed by a qualified electrician. The manufacturer reserves the right to refuse warranty service if
the product shows signs of damage due to incorrect maintenance or installation. Surface mounted installation only.
Do not install the product in high temperature or humid place.
INSTALLATION
1. Turn off the power.
2. Turn the lamp difuser to losen and and separate from the housing as shown in picture a.
3.Fix the housing with the expansion pipe and self-tapping screws as shown in picture b.
4.Locate the connection terminal block (shown in picture c.) Connect the commercial power wire to the terminal block using
double insulation cables (as shown in picture d).
5. Recheck if everything is well connected. Cover the housing with the lamp difuser and rotate to finish the installation (as
shown in picture e). Turn on the power.
6. Place decorative ring (if purchased) by pushing as shown in picture f.
a.
b.
c.
d.
e.
f.
WARNINGS:
*
Power should be cut off before installation, maintenance or inspection.
*
Please install and use the light strictly according to the instruction.
*
Do not disassemble or remold the product to avoid accident of electric shock or light failure.
ITEM NUMBER
ICEIP20FRW10WW
ICEIP20FRW10F
ICEIP20FRW16WW
ICEIP20FRW16F
ICEIP20FRW21WW
ICEIP20FRW21F
Input Voltage(VAC)
220-240V AC
Input Current(A)
80mA
130mA
160mA
Power(W)
10
16.5
21
Power Factor
>0.5
Color Temperature(K)
3000WW/ 4000F
Luminous Flux (Lm)
700 WW/ 800F
1555WW / 1600F
1800WW / 1850F
Beam Angle(°)
100
Working Temperature(°C)
-20-40
Measurements
Ø250*85mm
Ø350*86mm
Ø400*88mm
