ROBINHOOD RHTMF269W, Инструкция по установке и эксплуатации, Страница: 4 / 8

2
Installation
UNPACKING THE APPLIANCE
Remove the external & internal packaging.
When unpacking the appliance please check for any damage. If damage is found, do not connect to the power
source and contact the Authorised Service Provider.
Before connecting the appliance to the power source, let it stand upright for approximately 4 hours. This will reduce
the possibility of a malfunction in the cooling system from handling during transportation. Remove any protective
film from the outer surface.
Clean the interior surface with lukewarm water using a soft cloth.
ADJUSTING THE DOOR
1.Close upper door, take out the screw from the top hinge covers by cross screwdriver. Take off hinge cover, then
unscrew top hinge and take off upper door.
2.Unscrew from the middle hinge by cross screwdriver , then take off the lower door.
3.Laying down the refrigerator, take out the adjusting feet as below, then unscrew the lower hinge by cross
screwdriver.
4.Unscrew and remove the bottom hinge pin, turn the bracket over and replace it.
5.Refit the bracket fitting the bottom hinge pin. Replace both adjustable feet. Transfer the lower door to the
property position.
6.Make the middle hinge reverse the direction 180' C, then transfer it to the left property position. Make the middle
hinge pin in the upper hole of the lower door, then tight the screws.
7.Unscrew right middle stopper with metal block from bottom of upper door. And then install left middle stopper
and metal block in left side of bottom of upper door.
8 Install the upper door, fix the upper door hinge onto the cabinet.
9.Take left hinge cover from accessary bag and install it with top hinge. Then install hole cover at right side.