12
Configuration .
Connecting to your computer network
Before you can use your Stream 67 audio system to listen to Internet radio or to music streamed from your
computer, it must first be connected to your computer network.
This section of this book describes how to connect the audio system to your network using either the wireless
(WiFi) connection or the wired (Ethernet) connection.
The following instructions assume that you have just set up the clock and time options using the Setup Wizard
as described on the preceding page.
These instructions also apply to the Network Wizard in the Network Settings menu (from step 2 onwards).
1. After setting the
Daylight Savings options (see page 11)
, the display will show the 'Keep network connected?'
option. You should choose
'Yes'
if you wish to keep the audio system connected to the network when it is in
Standby mode. This will allow remote control software to switch on your audio system when needed.
If you choose
'No'
then your audio system will shut down its WiFi connection when it is in Standby, DAB,
FM, Bluetooth, CD or Aux-in modes. This minimises power consumption but it does mean that you will need
to switch the audio system on manually in order to use either Spotify Connect, the 'Play to / Cast to Device'
function or any remote control software such as the UNDOK app.
Press
Menu Left
or
Right
to highlight the required option and then press
Select
to make the selection.
After setting the Keep Connected option, the display will show a list of supported WiFi regional options.
Press
Menu Up
or
Down
to highlight the required region (for the UK choose
'Europe'
), and then press
Select
to make the selection. Do this even if you are planning to use the wired Ethernet connection. Your audio
system will then scan for available WiFi networks.
2. The audio system will enter the Network Settings Wizard and will display
'Scanning...'
. The audio system will
automatically scan both 2.4GHz and 5GHz WiFi bands. After a short while the display will show a list of the
available WiFi networks. If you are intending to use the WiFi connection go to step 3 on the next page.
To use the Ethernet connection to your router (with automatic configuration), press
Menu Up
or
Down
to
point to the
'[Wired]'
menu item. Press
Select
and the audio system will attempt to connect.
If your network allows automatic configuration (which is normal) the audio system will acquire a network
address. The screen should say
'Connecting...'
, and then
'Setup wizard completed'
. Press
Select
to exit the
setup wizard and show the Main menu. You can then skip to paragraph 10 on page 15.
*
Network settings
Keep network connected?
Wlan region
Europe
Network settings
Network wizard
Scanning...
Please wait
Waiting for
Ethernet
Jones family
[WPS] Paul’s network
Smith
Brown
[Rescan]
[Wired]
SSID