
11
Internet / DAB / DAB+ / FM RDS / Bluetooth / USB Smart Radio
Frequency Range
WiFi : 2.4 GHz / 5GHz
FM : 87.5 - 108.0MHz
DAB
/
DAB+ (Band III) : Channel block 5A-13F
DC in : 12V 1.5A
Batt. : 6 x 1.5V AA
/
AM-3
/
LR6
Roberts Radio Limited
PO Box 130, Mexborough,
South Yorkshire, S64 8YT, UK
Configuration
Plugging in and language selection
Your radio may be configured using either the display and buttons on the radio, or by
using the UNDOK app.
1. Plug the cable from the mains adaptor into the
DC input socket
located underneath
your radio (marked 'DC') ensuring that the plug is pushed fully into the socket and
place your radio on a flat surface.
2. Plug the mains adaptor into a wall socket and switch on the socket.
IMPORTANT:
The mains adaptor is used as the means of connecting the radio to
the mains supply. The mains socket and any multi-way mains block used for the
radio must remain accessible during normal use. In order to disconnect the radio
from the mains, the mains adaptor should be removed from the mains socket outlet
completely.
3. When you apply power, the display on the radio will light up and show a start up
screen for a few seconds.
If this is the first time that you use your radio (or after a Factory Reset) the display
will show the language menu.
4. By default your radio will display all menus and messages in English. Rotate
Tuning
to highlight the desired language. Press
Tuning
to enter the selection.
'Setup wizard'
and
'YES'
will be highlighted on the screen.
Note: If you wish to use UNDOK to setup your radio, please see page 19.
5. If you would like to setup your radio using the radio's controls instead of the UNDOK
app then press
Tuning
to select
'YES'
and to begin setting up your radio.
Continue on the next page.
Setup wizard
Start now?
English
Dansk
Nederlands
Français
Deutsch
Italiano
Language
*