If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
10
Operating the radio
Your clock radio is equipped with three tuning methods:- Scan tuning,
Manual tuning and Memory preset tuning. When switched-on your clock
radio will display the waveband and frequency in use.
Scan tuning
1. Press the
On/Off button
to switch on the radio.
2. Select the required waveband by repeatedly pressing the
Band
button
. On the FM waveband fully extend the
Wire aerial
located on
the rear of your clock radio - for MW and LW rotate your clock radio
for best reception.
3. Press and hold down either the
up or down button
buttons for more
the 0.5 sec and then release to commence scan tuning.
4. Your radio will scan the selected waveband and stop automatically
when it finds a station of sufficient strength. The station frequency will
appear in the display.
5. To recommence scan tuning, again press and hold down either the
up or down button
buttons for more the 0.5 sec and then release to
recommence scan tuning.
6. When the waveband end is reached the radio will beep and continue
tuning from the opposite waveband end.
7. Adjust the
Volume control
to the required setting.
8. To switch off your radio press the
On/Off button
.
3
3
1
2
8
7
