Using the radio for the
fi
rst time
1. Place your radio on a
fl
at surface.
2. Carefully fully extend the telescopic aerial located on the rear of your
radio.
3. Insert the adaptor plug into the DC socket located on the rear of your
radio. Plug the adaptor into a standard mains socket outlet. The display
will show
'WELCOME'
for a few seconds.
4. If this is the
fi
rst time that the radio has been used a scan of the Band III
DAB channels will be carried out. During the scanning process the
display will show the progress of the station search. The number on
the right of the display is the number of stations that have been found.
5. When the scan is completed the
fi
rst station (in numeric-alpha order
0...9, A...Z will be selected. The
fi
rst station in the list of stations found
during scanning will be played. The display will show the station name.
If no signals are found then it may be necessary to relocate your radio
to a position giving better reception. You should then carry out a scan
to
fi
nd stations as described on page 10.
•
Your radio has an indicator
on the display to indicate the strength
of the DAB radio signal being received.
6. Adjust the volume as needed using the
Volume
control.
IMPORTANT:
The mains adaptor is used as the means of connecting
the radio to the mains supply. The mains socket used for the radio must
remain accessible during normal use. In order to disconnect the radio
from the mains completely, the mains adaptor should be removed from
the mains socket outlet completely.
5
6