Robe clubspot 500 CT, Руководство пользователя

Страница: 10 / 26

10 11
Danger of fire ! When installing the device, make sure there is no highly
inflammable material (decoration articles, etc.) in a distance of
min. 0.5 m.
Warning ! Use 2 clamps to rig the fixture on the truss.
Follow the instructions mentioned at the bottom of the base.
Make sure that the device is fixed properly!
Ensure that the structure (truss) to which you are attaching
the fixtures is secure.
The projector can be placed directly on the stage floor or rigged in any orientation on a truss without altering its operation
characteristics.
For overhead use, always install a safety-rope that can hold at least 10 times the weight of the fixture. You must only use
safety-ropes with screw-on carabines. Pull the safety-rope through the two apertures on the bottom of the base and over
the trussing system etc. Insert the end in the carabine and tighten the fixation screw.
Fixation via the omega holders
1. Bolt each clamp (1) to the omega holder (4) with M12 bolt and lock nut through the hole in the holder.
2. Fasten the omega holders on the bottom of the base by inserting both quick-lock fasteners (3) into the holes of the
base and tighten fully clockwise.
3. Fasten the safety-rope (2) through the two apertures on the bottom of the base and over the trussing system.
1 - Shield
2 - Signal (-)
3
- Signal (+)
When installing fixtures side-by-side, avoid illuminating one fixture with another!
Before taking into operation for the first time,
the installation has to be approved by an expert!
4.8 DMX-512 connection/connection between fixtures
The fixture is equipped with 3-pin XLR sockets for DMX input and output. Only use a shielded twisted-pair cable designed
for RS-485 and 3-pin XLR-plugs and connectors in order to connect the controller with the fixture or one fixture with
another.
DMX - output DMX-input
XLR mounting-socket (rear view): XLR mounting-plug (rear view):
If you are using the standard DMX controllers, you can connect the DMX output of the controller directly with the DMX