11
Re-binding the transmitter
Note
: it will only be necessary to bind the system again
after a repair, or if you replace a component.
Move the throttle stick to the Idle position. Open the
transmitter battery compartment and insert the four AA
dry cells*. Switch the transmitter on.
Withdraw the canopy from the fuselage fairing (Fig. 1).
Carefully remove the upper cabin cover (Fig. 2). Slide
the fully charged LiPo flight battery into the helicopter's
support frame (Fig. 3) and connect it.
Do not move the model or the transmitter sticks. The red
monitor LED on the circuit board flashes. Press the Bind
button (Fig. 4). Release the Bind button again as soon as
the monitor LED starts flashing at a high rate: the model
is now in Bind mode. The procedure is complete when
the monitor LED reverts to a constant red.
* Please read the information regarding dry cells on page 4.
Correct procedure:
Fig. 1
Fig. 3
Fig. 4
Operating Instructions - BO 105 SR FTR RTF 2.4 GHz
Fig. 2
