5
TROUBLESHOOTING
If the Urn is not heating then:
Check that the machine is plugged into the
power point correctly and the power is
switched on.
Check that the electrical circuit supplying the
power point has not tripped. This could
occur if:
o
The circuit breaker has tripped. Too
many machine’s connected to the
circuit will exceed the current limit.
Remove some machines from the
circuit and try again.
o
The Earth Leakage Device has
tripped. It is normal for heating
element devices to leak some
current through the insulation to
Earth. If multiple machines with
heating elements are connected to
the same circuit it could exceed the
leakage current limit. Remove some
machine from the circuit and try
again.
Check that the Urn is switched to the ON
position. The green pilot light indicates the
urn is on and power is available. If the green
light is not on check the power point is not
faulty.
In Variable mode check that the Thermostat
is turned on by rotating it clockwise to an
appropriate temperature setting. The amber
pilot light indicates the urn is heating.
If the unit has boiled dry, turn the machine
off, allow to cool, tilt backwards and press
the reset button located on the base of the
machine, refill the machine with cold water
and turn it back on. See Operation.
If the Urn boils continuously:
For Variable Mode turn down the thermostat
to below 100°C and check whether the
amber pilot light turns off.
For Preset Mode check your altitude above
sea level. The Preset thermostat may boil
continuously at high altitudes above 800m.
This is because the boiling point of water
decreases as altitude increases. It is not
possible to recalibrate the internal
thermostat for high altitude use. Use
Variable Mode only at high altitudes.
SPARE PARTS
Common
EC0519
Plug & Cord – 10A
EC0385
Pilot Light – Green
EC0386
Pilot Light – Amber
EC0407
On/Off Switch
EC0457
MODE Selection Switch
MC1087
Tap Top Assembly (Top Only)
MC1088
Tap Assembly Complete
PC0589
Tap Tank Seal
PC0456
Plastic Tank Washer 8.2OD,
4.0ID
PC0060
Cord Clamp 10A
PC0453
Sight Glass Upper Mount
TC0037
Fixed Thermostat 95°C
TC0049
Boil Dry Cutout
PC0593
Push Rod – Boil Dry Cut-out
TS0025
Variable Thermostat & Knob
PC0591
Base Access Panel
PC0594
Dial / Knob Thermostat
UDS10VP
MS0458
Sight Glass Assembly 10L
PC0464
Base 10L
VS0253
Side Handle Kit 10L
VS0254
Lid Assembly 10L
TC0051
Thermal Fuse Link
UDB10VP
