Roar Quad 15, Руководство пользователя

Страница: 19 / 28

19
8.5 S
TEREO
S
ETUP
–
WITH EFFECTS AND MIDI
-
FOOTCONTROLLER
The ultimate setup for the demanding lead guitarist. Three speakers retain clarity for stereo sounds and provide the
sound engineer with the dry/direct signal for better control behind the mixing desk.
• The center speaker (Rackcombo in this example) delivers the dry mono signal.
• The two extension cabinets deliver the wet signal processed by the stereo rack effect unit.
• Use the Pre-gain loop for your favorite overdrive pedal, booster, EQ, noise gate, etc. (Programmable on/off)
• Use the Post-gain effect loop for your favorite EQ, Noise gate, delay, tremolo, etc. (Programmable)
• Connect a mono jack cable from the Quad15’s “AMP OUT” jack to the stereo effect processor for stereo
effects like delay, reverb, chorus, phaser, pitch shifter, panner, etc.
• Connect the stereo output from the effect processor to a 2 channel power amp.
• Use the Power Attenuator of the Quad15 as a master volume for the entire setup.
• Connect a tuner or recording system to one of the two “Guitar out” outputs on the rear panel of the Quad15.
Warning! AVOID GROUND LOOPS to minimize hum and noise.
Use a power supply with isolated outputs when you insert an effect pedal in both “Pre-gain loop” and “Effect loop”.
Make sure the jack connectors for the “Pre-gain loop” don't touch the jack connectors for the “Effect loop”.