12
To do this, do the following:
1. Open the battery cover on the back of the remote control.
2. Use a pen tip or similar item to press the MENU button. When holding the remote
control vertically, it is located above and to the left of the batteries.
3. Press the red FIND button on the front of the remote control.
4. Press the MENU button again, and replace the battery cover.
Pairing a remote control with a Camera
An ONYX HD camera always corresponds with a specific ONYX HD remote control.
To match or pair another remote control with your camera, do the following:
Important:
An unfolded paper clip is required for this procedure. Because the
following tasks must be performed within a specified time limit, review and make sure
that you understand this procedure before attempting to pair a camera and remote
control.
1. Use an unfolded paper clip to press and release the recessed PAIRING button on
the bottom of the camera.
2. Open the battery cover on the back of the remote control. Insert and press the
unfolded paper clip into the recessed PAIRING button (the hole above and to the right
of the batteries when holding the remote control vertically).
The remote control’s LED will flash approximately 10 times.
Note:
This must be done within 10 seconds after pressing the camera’s PAIRING
button.
3.
Press the remote control’s green POWER button.
The green LED on the bottom of the camera turns on. This indicates that the camera
and remote control are correctly paired. Replace the battery cover on the remote
control.
Transporting the Unit
An optional wheeled carrying case is available for all units except the 24-inch model.
Before packing the unit, do the following:
1. Use the remote control to power off the unit, and then flip the main power switch to
the off position.
2. Disconnect the power connector from the wall and the unit.
3. Lower the camera.
4. Place the power cord into the case or its front pocket.
To place the unit into the carrying case, do the following:
1. Lift the unit by its carrying handle.
