Power and Data socket
DATA1: Data and power input socket 1
Input data is PPM or UART digital signal, which can be switched through
SW3.Voltage range is 10~14VDC, typically 12VDC. Exceeding normal range of
operation will result in increasing failure rate, or even permanent damage.
DATA2: Data and power input socket 2
Functions are the same as DATA1.
Notes:
When using the PPM mode, 10CH PPM signal can be input through DATA1.
The corresponding output of the UHF receiver is 1-10CH. DATA2 can also input
10CH PPM signal, the corresponding output of the UHF receiver is 11-20CH.
When using UART digital signal, the functions of DATA1 and DATA2 are
identical, either of which can be connected with signal acquisition system and
input 20CH data.