10.2.1. Adjusting the Output Line Level
To adjust the output line level:
1. Open the
Analog Output Configuration
tab in the
OUTPUT
section.
2. Initially, the cursor will highlight all output channels. To accept this, rotate the encoder to move the
cursor to the current reference level.
3. Alternatively, pressing the encoder on the channel strip allows the selection of an individual channel.
Cursor (current channel)
Input Reference Level
4. Move the cursor to the current
line level
and push it.
5. Rotate the encoder to change the setting and confirm by pushing the encoder again.
To adjust the output line level on the web remote:
1. Select an analog output channel by clicking the corresponding channel strip. The channel strip turns
blue.
2.
(optional)
Click and drag left or right to select multiple channels.
3. Press one of the buttons for
+13 dBu
,
+19 dBu
or
+24 dBu
below the selection. The selected value is
shown within the level meter.
RME M-1610 Pro User’s Guide
10.2. Analog Outputs |
46
