9.3. AVB Input Streams
The AVB streams
received
by the M-1610 Pro are referred to as "input streams". For these streams, the
device acts as an
AVB Listener
.
To establish a connection between a talker and a listener, an
AVDECC Controller
is required. The M-1610
Pro does not include an AVDECC Controller.
AVB input streams are monitored as follows:
Description
Indicator
Possible solution
Disabled
grey
Create connection with AVDECC
controller
Streaming/Receiving
green
No Data
red
Verify proper talker configuration
SR Mismatch
red
Verify that the sample rates of talker and
listener are identical
Waiting
yellow …
Waiting for talker to be ready
Talker Fail
red
Verify proper talker configuration
No Bandwidth
red
Use faster network speed (1 GBit/s
instead of 100 MBit/s)
Domain Boundary
red
Reconnect all devices and reboot switch,
ensure only AVB switches are used
Internal Error
red
Reboot device
9.3.1. Change AVB Input Stream Size
Each of the eight AVB streams can have a size of 1-8, 12 or 16 channels in AM824 and AAF stream
formats, or 0 channels in CRF Media Clock stream format.
To change the amount of channels and format of incoming AVB streams on the device:
1. Open the
AVB
tab in the
INPUT
section.
2. Move the cursor to highlight the corresponding AVB stream
size
and press the encoder.
3. Rotate the encoder to configure a new stream size and format, then confirm by pressing the encoder
again.
RME M-1610 Pro User’s Guide
9.3. AVB Input Streams |
42
