3.14. Network Connection
On the rear of the 12Mic-D, two ruggetized RJ45 connectors labeled
NET (PRI)
and
NET (SEC)
provide
ethernet connectivity. The supported link speeds are
1 Gb/s
and
100 Mb/s
.
A green LED (left,
LINK
) signals a successful link. A yellow LED (right,
ACT
) signals network traffic
(blinking).
Both straight and crossover cables can be used (
Auto MDI-X
). Cable lengths of up to 100m are supported
when using Cat 5e or higher classification.
The network ports are used to send and receive:
• up to
64 audio channels
when connected to a Dante® network, and
• remote status/control with
HTTP
over IP routed networks.
The current link state is also shown on the display of the 12Mic-D.
Two network port icons in the menu reveal the following
states:
Icon
Description
No link - cable not connected
Negotiating link with other endpoint
Successful link with speed of 100 MBit/s
Successful link with speed of 1 GBit/s
The two ethernet ports can be configured with the
Dante Controller
in
Device View > Network Config >
Dante Redundancy
. If both ports are connected to the same network, for example to create a daisy-chain
of several 12Mic-D, then the setting must be changed to
Switched
. In the default mode, the device is
configured so that each port connects to separate networks (
Redundancy
).
RME 12Mic-D User’s Guide
3.14. Network Connection |
16
Содержание 12Mic-D
Страница 2: ...RME 12Mic D User s Guide...
