Network
Connection
Power
Connection
Status
LED
Configuration
Button
Network Communications Information
Consult your IT administrator and determine the following network
settings for your F200:
• IP Address ____________________________________
• Subnet Mask __________________________________
• Default Gateway _______________________________
© Raymond & Lae Engineering, Inc. 2011. All rights reserved. RLE® is a registered trademark and Seahawk™, Falcon™, and Raptor™
are trademarks of Raymond & Lae Engineering, Inc. The products sold by RLE Technologies, 104 Racquette Dr., Fort Collins, CO 80524
are subject to the limited warranty, limited liability, and other terms and conditions of sale set forth at http://www.rletech.com.
Before you begin, gather the following equipment and information:
F200 Startup Guide
Thank you for purchasing a Falcon F200. This guide will help you power up and connect
the F200 to your network. Once the F200 is online, use the F200 Configuration Guide to
complete the configuration and installation process.
Before you begin, consult our website - rletech.com - to ensure you’re working
with the most recent version of documentation for this product.
If you need further assistance, contact RLE Technologies at [email protected].
F200: Power Connection and Status LED
Power Connection
The F200 is powered through its mini USB port. RLE approves the following sources to power the F200:
• The included wall wart
•
A computer plugged into a wall outlet (not an undocked laptop)
•
A USB hub that provides 500mA of power to the F200 and is powered by an external power supply plugged into a wall outlet.
Using the included power cable, plug the mini end of the USB cable into the F200; plug the standard USB connection into an approved F200
power source.
Status LED
There are a variety of alarm and alert patterns and colors programmed for the F200’s LED. You may see the following codes during the basic
setup process. Other codes are programmed into the F200, and are described in the F200 Configuration Guide found at rletech.com. During
setup, use the following chart to determine which alarms are active:
Blink Pattern
Status Description
Green / Off (Intermittent)
Normal status - no alarms are present
Yellow / Off
No network connection
Red / Magenta
Call RLE - the F200 has an internal error
Establish Network Communications
Consult your IT department before performing these steps. If you intend to change the IP address or subnet mask, obtain appropriate
addresses from your IT department.
The F200 ships with the following default settings:
Default IP address: 10.0.0.188 Default Gateway: 10.0.0.1 Default Subnet Mask: 255.255.255.0
Option 1 - Basic Setup: Set a Static IP Address
The F200 ships with a static IP of 10.0.0.188. You can change this IP address so it is more compatible with your network.
Included in the package with the F200 device
Network cable, 5V USB wall wart, USB cable - USB mini B to USB A
The F200’s serial number is found on the white sticker affixed to
the bottom of the unit.
•
F200 Serial Number _____________________________
v4.1
Compatible with firmware version 4100.1 and above
(12/2016)
