146 • Using Maintenance Mode
Gas Tracer Operator’s Manual, CSA Version
AUTO CAL is set to On. The bump test time is deducted from the calibration
time. For example, if the CAL TIME is set to 90 seconds and the GAS TIME is
set to 30 seconds, if the bump test fails, the Gas Tracer will only be exposed to
gas for an additional 60 seconds. With the cursor next to the cal time value and
CAL TIME displayed along the bottom of the screen, press and release the
POWER ENTER button. The value will begin to flash. Use the AIR
▲
or
(SHIFT)
▼
buttons to select a new cal time value. The choices are 90 and 120
seconds. Once a value is selected, press and release the POWER ENTER
button to save it. The value will stop blinking.
6. To update the AUTO CAL setting, use the (SHIFT)
▼
button to scroll to the
AUTO CAL value. The factory setting is ON. With AUTO CAL set to ON, if a
bump test fails, the unit will automatically begin a calibration. If AUTO CAL is
set to OFF and a bump test fails, nothing will happen. With the cursor next to
the auto cal selection and AUTO CAL displayed along the bottom of the
screen, press and release the POWER ENTER button. The value will begin to
flash. Use the AIR
▲
or (SHIFT)
▼
buttons to select ON or OFF. Once a selection
is made, press and release the POWER ENTER button to save it. The value will
stop blinking.
7. To exit the BUMP--SET menu, use the (SHIFT)
▼
button to scroll to ESCAPE
and press and release the POWER ENTER button.
Updating the Confirmation Beep Setting
With BEEP. SET set to ON, the Gas Tracer beeps once every 5 minutes to verify
that it is operating.
With BEEP. SET set to OFF (factory setting), the Gas Tracer does not sound a
confirmation beep.
1. Use the AIR
▲
or (SHIFT)
▼
buttons to display the BEEP. SET menu item.
Press and release the POWER ENTER button. The screen will indicate the
current setting.
2. Use the AIR
▲
or (SHIFT)
▼
button to display the desired setting.
3. Press and release the POWER ENTER button to save the setting and return to
the main menu.
On
MAINTENANCE
BEEP. SET
