AirLink 6940XP Operator’s Manual
Sensor Settings and Calibration
•
44
Sensor Radio Address
The AirLink 6940XP sensor radio addresses are adjustable from 1 to 255. Each of sensor that is
turned on has its own radio address, and
the address for each sensor must be set to a different
value
.
Each of the AirLink 6940XP sensor assemblies must have a unique address on the network in
order to avoid a fault at the receiving monitor. The default address for Sensor 1 is 1, Sensor 2 is 2,
Sensor 3 is 3, and Sensor 4 is 4.
1. If necessary, enter the Product Settings and Configuration menu by pressing and holding
MENU
for approximately 6 seconds.
Press and release
ADD
or
SUB
to navigate to the desired sensor settings menu, then press
MENU
to select the menu.
2. Press and release
ADD
until the “Radio Address” menu item appears. Press
MENU
to select
the “Radio Address” menu item.
3. Press and release
ADD
or
SUB
to increase or decrease the sensor radio address respectively.
The AirLink 6940XP will skip past radio addresses that are in use by the other AirLink
6940XP sensor assemblies.
4. Press
MENU
or
BACK
to save the radio address setting and return to the Sensor Settings
menu.
