Riverbed SteelHead 5080, Руководство по установке и настройке

Страница: 52 / 94

52 | Troubleshooting
IP address configuration
4. Click Apply to apply your settings to the current configuration.
5. Click Save to save your settings permanently.
IP address configuration
If you have not configured IP addresses correctly, the SteelHeads can’t connect to each other or to your
network.
Solutions
To verify the IP address has been configured correctly:
• Ensure the SteelHeads are reachable through the IP address by pinging their primary and in-path
interfaces.
• Ensure that the SteelHeads in the network can reach each other through their own interfaces.
Connect to the SteelHead CLI. For details, see the Riverbed Command-Line Interface Reference
Manual . Enter this command to ping from a specific in-path interface on a SteelHead to another in-
path interface:
ping -f -I <local-steelhead-inpath-ip> -s 1400 <remote-steelhead-inpath-ip>
• Ensure that the default gateways, both for the SteelHead and for its in-path interfaces, are correct.
• For physical or virtual in-path installations, verify that the server-side SteelHead can be auto-
discovered by the client-side SteelHead.
Connect to the SteelHead CLI. For details, see the Riverbed Command-Line Interface Reference
Manual . Enter the command:
tproxytrace -i inpath0_0 <server-ip-address>:<server-tcp-port>
This causes the SteelHead to generate a fake TCP SYN packet, destined for the specified IP address
and TCP port, and send it to the specified in-path interface. A remote SteelHead should respond if it
sees the SYN packet.
• Verify that the client-side SteelHead is visible to the server-side SteelHead.
Connect to the SteelHead CLI. For details, see the Riverbed Command-Line Interface Reference
Manual . Enter the command:
tproxytrace -i inpath0_0 <client-ip-address>: <client-tcp-port>
Optimize only the following
extensions Specify a list of extensions you want to include in overlapping opens
optimization.
Optimize all except the
following extensions Specify a list of extensions you don’t want to include. For example, you
should specify any file extensions that use Enable Applock Optimization.
Control Description