Riverbed SteelHead 5080, Руководство по установке и настройке

Страница: 38 / 94

38 | Installing and Configuring the SteelHead
Configuring in-path SteelHeads
configure terminal
configuration jump-start
For detailed information about the CLI, see the Riverbed Command-Line Interface Reference Manual .
Verifying you are connected to the SteelHead
Perform these tasks to verify that you have properly connected the SteelHead.
To verify you are connected to the SteelHead
1. Verify that you can connect to the CLI using one of these devices:
– An ASCII terminal or emulator that can connect to the serial console. It must have these
settings: 9600 baud, 8 bits, no parity, 1 stop bit, vt100, and no flow control.
– A computer with a Secure Shell (SSH) client that is connected to the SteelHead primary port.
2. At the system prompt, enter this command:
ssh admin@<host>.<domain>
— or —
ssh admin@<ip-address>
3. You are prompted for the administrator password. Enter the password you set in the configuration
wizard.
4. At the system prompt, ping from the management interface:
ping -I <primary-ip-address> <primary-default-gateway>
5. At the system prompt, ping from the in-path default gateway:
ping -I <in-path-ip-address> <in-path-default-gateway>