Riverbed SteelHead 5080, Руководство по установке и настройке

Страница: 31 / 94

Installing and Configuring the SteelHead | 31
Powering on the system
This checklist lists the parameters you specify to complete the initial configuration of the SteelHead. Be
prepared to provide values for these parameters.
Powering on the system
This section describes how to connect the AC power and how to power on the system.
Caution: In European electrical environments you must ground (earth) the green/Yellow tab on the power cord, or
risk electrical shock.
To power on the system
1. If your system has a master power switch, ensure that the system and master power switch is in the
off position on the rear of the SteelHead.
Appliance Parameter Your value
SteelHead (the Primary
Interface) Host name
IP address
Netmask
Default gateway (the WAN
gateway)
DNS IP address
Domain name for the system
Administrator password
SMTP server IP address
Events and failures notification
email address
Primary interface speed
Primary interface duplex
In-Path Deployments In-path interface IP address
In-path netmask
In-path gateway
In-path: LAN interface speed
In-path: LAN interface duplex
In-path: WAN interface speed
In-path: WAN interface duplex