Riverbed SteelHead 5080, Руководство по установке и настройке

Страница: 30 / 94

30 | Installing and Configuring the SteelHead
Preparing your site for installation
• SteelHead primary interface
These symptoms can be signs of a duplex mismatch:
• The Link Duplex alarm triggers.
• On the Reports > Diagnostics: System Logs page you see errors for sends, receives, cyclic
redundancy checks (CRC), and short sends.
• You can’t connect to an attached device.
• You can connect to a device when you choose automatic negotiation, but you can’t connect to
that same device when you manually set the speed or duplex.
• Slow performance across the network.
For detailed information about checking for duplex mismatches, see Chapter 4, “Troubleshooting.”
Bypass card interface naming conventions
The interface names for the bypass cards are a combination of the slot number and the port pairs
(<slot>_<pair>, <slot>_<pair>). For example, if a four-port bypass card is located in slot 0 of your
appliance, the interface names are lan0_0, wan0_0, lan0_1, and wan0_1, respectively. Alternatively, if
the bypass card is located in slot 1 of your appliance, the interface names are lan1_0, wan1_0, lan1_1,
and wan1_1, respectively.
For detailed information about installing additional bypass cards, see the Network and Storage Card
Installation Guide .
Completing the configuration checklist
Before you begin, consult the Rack Installation Guide for detailed information about how to install your
model to a rack.