Riverbed SteelCentral NetExpress 470, Руководство по модернизации и обслуживанию

Страница: 134 / 140

134 Upgrade and Maintenance Guide
Monitoring and Managing xx70, Interceptor 9600, and Core 3500 Appliances with BMC Setting Up the BMC for Initial Access
Setting Up the BMC for Initial Access
Before you can access the BMC, you need to configure its network settings.
Note: On 1U appliances, BMC uses the AUX port of the appliance for communication; 2U appliances have a dedicated
port for communication.
Setting Up BMC on SteelHead and SteelFusion Core 3500
For SteelHead and SteelFusion Core, you set up BMC through the CLI.
To configure the BMC on a SteelHead or SteelFusion Core 3500

Enable DHCP on the remote management port with this command:
(config) # remote dhcp
— or —

Set up a static network configuration using the remote ip address , remote ip default-gateway , and
remote ip netmask commands.
The BMC address can be on a different subnet than the appliance. (Make sure that the routers are
configured to support a different subnet.)
To verify the network configuration

Enter the show remote ip command:
(config) # show remote ip
DHCP: Enabled
IP Address: 192.168.229.185
Netmask: 255.255.255.0
Gateway: 192.168.229.1
Mac Address: 99:0e:b6:b0:2e:2f
Setting Up BMC on NetProfiler
For NetProfiler, you configure BMC through the Web interface.
To configure the BMC on NetProfiler
1. Choose Configuration > General Settings in the Web user interface.
2. In the Baseboard Management Controller Settings section, click Edit in the Action column and specify
the network settings for the BMC.
Consult the NetProfiler online help for details.
Setting Up BMC on NetShark
For NetShark, you set up BMC through the CLI.