Rittal Liquid Cooling Package
9
3 Device description
EN
Fig. 5:
Arrangement of the partitioning plates (air baffle plates)
for devices with sideways air throughput
Key
1
Cold ambient air
2
Partitioning plate in the front section
3
Installed devices
4
Cold airflow in the server enclosure
5
Hot airflow in the server enclosure
6
Partitioning plate in the rear section
7
LCP Hybrid with air/water heat exchanger
8
Cooled air
Additionally, please observe the following regarding in-
stalled equipment in the server enclosure:
Ensure that the 482.6 mm (19") equipment is distrib-
uted as evenly as possible inside the server enclosure.
This prevents selective loading of the heat exchanger.
Install heavy equipment with high heat generation at
the bottom of the server enclosure, and passive com-
ponents with low heat generation at the top.
If the server enclosure is not fully populated, seal the
open height units (U) in the 482.6 mm (19") level with
blanking plates, available as Rittal accessories (see
section 12 "Accessories").
3.3
Equipment assembly
3.3.1
Unit components
Fig. 6:
LCP Hybrid – Door closed
Key
1
LCP door with air/water heat exchanger
2
Door bracket
3
Cooling water connection
4
Door handle
5
Server enclosure
The Liquid Cooling Package is comprised of a rear door
with heat exchanger and a side frame.
The door is fitted with a special door bracket at the rear
of the server enclosure, and seals the server enclosure
with 4-point locking.
There is a maintenance door fitted on the inside of the
Liquid Cooling Package. Whilst closed, this provides ac-
cess protection for the heat exchanger.
Note:
Foam strips may also be used as an alterna-
tive to air baffle plates.
1
6
7
8
4
5
2
3
2
4
1
5
3
