Rittal BC 1007 HS, Руководство пользователя

Страница: 16 / 92

16
3.2.3 Pressure Plate Replacement
Replace the pressure plate by following the reverse procedure noted in section 3.2.2. Make
note of the tips below.
Note: Do not loosen or adjust the Guide Shaft End Stop Bolts, this will change the Zero reference for
the pressure plate.

Insure the pressure plate, guide shafts
and guide shaft bushings are
completely free of buildup, dirt and
metal shavings.

Apply a light coat of oil to the guide
shaft bushings.

Apply a light coat of oil to the upper
and lower guide shafts.

The guide shafts should move freely
before connecting to the pressure
plate.

When installing the guide shafts, be
sure that the Guide Shaft end stops line
up with the end stop bolts and they do
not contact the spindle mounting plate.

When the pressure plate is fully installed, the plate should slide in and out freely
(When compressed air is turned off).

If a bind is felt, adjust the alignment of the upper and lower guide bolts and
recheck the movement. The pressure plate must be evenly spaced between the
two guide shafts or binds will be felt when moving in or out.
o
Try loosening the guide shaft bolts and check for binds, if no binds were
detected, adjust the guide bolt location (by lifting or lowering the pressure
plate) and slowly tighten.
o
If a bind is still detected after loosening the guide shaft bolts, there is likely
debris in the bushings or on the guide shaft. Remove and clean.