Rittal AS 4050.451, Руководство по эксплуатации

Страница: 13 / 21

5 Maintenance
Ritta l S22 insulation stripping machine We reserve the right to make technical m odifications. 13
EN
Manual mode
◼ Keep the touch display pressed during switch on.
Menu 2 "Manual" is displayed flashing.
◼ In manual mode, the motor can be adjusted slowly with touch contact during
jogging.
◼ If the touch display is pressed for at least 3 seconds, a switch is made back to
menu 1 "Display".
4.8.3 "Counter" menu
◼ Select menu 3 "Counter" To do this, press the touch display for at least 3 sec-
onds.
Symbol Description
Total counter
Day counter
Service counter
◼ Exit the menu: press the touch display briefly.
◼
Clear the day counter: press the touch display for at least 3 seconds.
◼ When starting the insulation stripping, the menu is exited automatically and
menu 1 selected.
5 Maintenance
Caution!
Risk of injury at the blades.
◼ Never touch the blades.
5.1 Emptying the stripped insulation scrap container
◼ Withdraw the stripped insulation scrap container, empty it and reinsert it to the
limit stop.
5.2 Interior
Note:
The machine interior should be cleaned and oiled in six-monthly in-
tervals or after 50,000
– 100,000 activations.
◼ Loosen the screws and remove the front panel.
◼ Remove the stripped insulation scrap and any contamination.
◼ Oil very sparingly the wire-holding pliers (inner side of the front plate) and the
pressure-ball screws (fig. 9) with standard motor oil.
◼ Close the front panel. To do this:
– Push the actuator level to the left.
– Place the front panel and, by moving from right to left, fasten it to the front
frame of the machine (attach with the alignment pin on the right-hand side).
– Fasten the front panel with the screws.