Rittal 4055.710, Руководство по эксплуатации

Страница: 12 / 20

9 Replacing the cutting blade
EN
12 We reserve the right to make technical modifications. Rittal stationary busbar cutting unit CW 120-S
9 Replacing the cutting blade

Place the unit without material securely on the table.
Fig. 5: Blade in the lower position

Activate the hydraulic pump and allow the blade to travel down until only a
small curvature (1) can be seen between the blade and the counter cutter.

Switch off the hydraulic pump and immediately disconnect the hydraulic cou-
pling (2) at the cutting unit so the cutter bar remains at the bottom position.
Fig. 6: Dismantling the retainers

Dismantle the two retainers (3) and the side protective inspection window (4).
Caution!
When replacing the cutting blade, there is the risk of injury
caused by sharp edges.

Ensure that the blade replacement is performed by appro-
priately authorised persons.

Wear your personal protective equipment when replacing
the cutting blade (see section 2.4 "Personal protective
equipment").