Operating Manual Version 6.3-04 of 10.10.18
28
ATTENTION!
The SCENAR device switches itself off after
60 seconds if no button has been pressed and there is no skin contact.
6.1.4
When the treatment is over, it is recommended to reset to d e-
fault settings (refer to item 5.1.2). Switch the SCENAR device off (re-
fer to item 5.1.5).
6.2 SCENAR SPORT
6.2.1
The Instruction for Use is the main document to be consulted
with when delivering treatment with the SCENAR device.
6.2.2
To switch the SCENAR device on press and hold the
‘ ’
button
(for about 2 sec) until the single beep sounds and the
‘
’
LED
lights up.
ATTENTION!
All
set stimulation modes (except for energy) are re-
tained after the SCENAR is switched off.
Reset the SCENAR device to the default settings if necessary (when
you start treating a new patient) (item 5.2.2).
6.2.3
Place the electrode on the patient's skin. Wait for several se-
conds to make sure a patient does not have unpleasant sensations. Press
and hold the
‘ ’
button until the first pricking sensation, vibration or for-
mication at the comfortable level.
ATTENTION! To avoid uncomfortable and painful sensations of
a patient,
it is recommended to set the energy to minimum (by
pressing and holding the
‘
’
button until the intermittent audio
signal sounds) before the start of procedure or when going to treat
the most sensitive skin areas.
ATTENTION!
The SCENAR device switches itself off after 60 se-
conds if no button has been pressed and there is no skin contact.
6.2.4
When the treatment is over, it is recommended to reset to d e-
fault settings (refer to item 5.2.2). Switch the SCENAR device off (re-
fer to item 5.2.5).
6.3 SCENAR BASIC
6.3.1
The Instruction for Use is the main document to be consulted
with when delivering treatment with the SCENAR device.
6.3.2
To switch the SCENAR device on press and hold the
‘
’
button
(for about 2 sec) until the single beep sounds and the
‘
’
LED
lights up.
ATTENTION!
Set stimulation mode is retained after the SCENAR is
switched off, while the energy level is set to minimum.
Reset the SCENAR device to the default settings if necessary (when
