Operating Manual Version 6.3-04 of 10.10.18
21
4.2.13
To switch the SCENAR device on with the energy level set be-
fore it was switched off press and hold the
‘ ’
and
‘
’
buttons (for about
2 sec), until the SCENAR device emits an intermittent high-pitch beep.
ATTENTION!
When the SCENAR device is switched on with the
energy level set before it was switched off, the sound indication is
different from default.
4.3 SCENAR BASIC
Fig.9 shows the SCENAR Basic device exterior.
Fig.9
4.3.1
On the back side of the casing (1) there is a built-in electrode (2)
and a battery cover (12).
4.3.2
On the upper side of the casing there are following indicators:
3
–
‘
’ LED
– indicates the energy level (stimulus strength);
4, 5
LEDs
– the visual indicators of general purpose;
6
–
‘F1’
LED
indicates the Dosing mode with the constant fre-
quency of 60 Hz and ‘
Am
’ (‘
F1
’ mode);
7
–
‘F2’
LED
– indicates the mode with the constant frequency
of 90 Hz while the number of pulses in a batch and the gap be-
tween the pulses are controlled automatically (
‘F2’
mode).
The
4, 5
,
‘F1’
and
‘F2’
LEDs are as well used:
to indicate stimulation energy level (when adjusting the energy):
4
– from minimal energy to 25 %;
4, 5
– from 26 to 50 %;
4, 5, ‘F1’
– from 51 to 75 %;
