RITE-HITE Wheel-Lok GWL-2300, Руководство пользователя

Страница: 15 / 52

Rite-Hite ® Global Wheel-Lok™ GWL-2300
Owner’s Manual
Publication: 00007-AM-EN 2016-08-08 15
MAINTENANCE
(Based on typical applications of 8 trucks per day)
!
DANGER
When working with electrical or electronic
controls, make sure that the power source
has been locked out and tagged according to
approved local electrical codes.
Post safety warnings and barricade work area, at
dock level and at ground level, to prevent
unauthorized use of the dock position.
!
WARNING
A safe work place requires all lights and the horn
to be working properly. DO NOT use DOK-LOK
vehicle restraint if parts are broken or missing.
NOTICE
Maintenance may be required more frequently
at loading docks exposed to harsh environments
(extreme climates, corrosive chemicals, frequency
of usage exceeding 8 trucks per day, etc.). Consult
RITE-HITE if these conditions exist for accelerated
maintenance requirements.
NOTEE: Your local RITE-HITE ® representative provides
a Planned Maintenance Program (P.M.P.) which can
be fitted to your specific operation. Call your local
representative.
Daily
1.
Remove dirt, snow, ice and debris around GWL-2300
vehicle restraint.
2. Verify inside, outside lights and horn are working.
3. Replace damaged or missing light bulbs and lenses.
4.
Repair, remount, or replace outside and inside signs
as required.
5. Inspect dock bumpers. Missing bumpers must be
replaced.
90 Days
Grease Barrier Roller
At Fitting -
Use Mobilith SCH220
No. 2 Grease
Grease Rollers (8) At Fittings -
Use Mobilith SCH220
No. 2 Grease
Both Sides
Grease Trolley Pin
At Fitting -
Use Mobilith SCH220
No. 2 Grease
Lubricate Pawl Shaft & Lifting Rail Slots
Dry Lubricate Only - DO NOT USE Moly Based Grease
FIGURE 12 - LUBRICATION
A
B
C
D
1. Perform all Daily maintenance.
2. See Figure 12. Grease rollers at fittings located on
both sides of trolleys (8 places) (A), lock arm (B) and
barrier roller (C). Use Mobilith SHC220 No. 2 grease
or equivalent temperature range lithium based grease
(Two (2) to three (3) pumps with a grease gun).
3.
Lubricate Pawl Guide Shaft and Lifting Rail Slots with
a Dry Spray Lubrican
(D) with a Dry Spray Lubricant
DO NOT USE Moly-Based Grease.
4. Check the trigger and rollers for damage, ensure
rollers spin freely.
5. Check brushes on trolleys and replace as necessary.
6. Inspect outside junction box, light box and power unit
enclosure. They should be rigidly mounted. If loose or
damaged, inspect all wires and wire connections.
7.
Inspect flexible conduit from GWL-2300 vehicle
restraint to junction box. Look for kinks, crushed
areas, etc.
8.
Perform operational test after all maintenance repairs
are complete.