RITE-HITE Dok-Commander, Инструкция по установке/обслуживанию/эксплуатации, Страница: 29 / 40

Rite‑Hite
®
Installation/Service/Owner's Manual
Dok‑Commander
®
Publication: AMEN00070 2020-01-30 29
MAINTENANCE
Troubleshooting
Setting Horn Override Code
To create a new or replace a forgotten code:
1 Press and hold DIAGNOSTIC button until horn chirps
(≈ 5 seconds).
or
Without opening control box cover, press and hold #1
and #3 buttons on cover until horn chirps
2 Enter factory preset HORN OVERRIDE code: 1223
(horn will chirp)
3 Enter new HORN OVERRIDE code It can be
1 to 4 numbers in length
4 Press LOCK button New HORN OVERRIDE code is
enabled
Enter Hydraulic Fill Mode
1 Press and hold DIAGNOSTIC button inside control
box until horn chirps (≈ 5 seconds).
or
Without opening control box cover, press and hold #1
and #3 buttons on cover until horn chirps
2 Press HORN OVERRIDE #2 button
(horn will chirp)
3 System is now in FILL MODE Press and hold
LOCK and UNLOCK buttons to run unit up or down,
respectively
4 Cycle Dok-Lok up and down to remove air from
system Add remaining hydraulic fluid Stop cycling
once Dok-Lok barrier travels up and down without
hesitation
5 To exit FILL MODE:
• Press DIAGNOSTIC button, or
• Press no buttons for 5 minutes, or
• Cycle power
Fill Mode Input/Outputs Chart
C = Chirp on State Entry
F = Off
P = Pulsing / Flashing
T = Steady On
MICRO CONTROL BOARD POWER BOARD
INPUTS OUTPUTS
PUSH
BUTTONS
12VDC 115/230VAC
Lock Unlock Horn Silence Inside Red light Inside Green light Corner-V
u Red light [CVU RD]
Corner-V
u Green light [CVU GRN]
Leveler-V
u Red light [L
VU RD]
Leveler-V
u Green light [L-VU GRN]
Outside Red light [OSR] Outside Green light [OSG] Dok-Lok horn [HORN] Leveler Motor Contactor [COMBINED POWER UNIT
ONL
Y]
Motor Ouptut #1 [M1/LOCK] Solenoid #1 (RSOL1 / RAISE) Solenoid #2 (RSOL2 / DIVER
T)
[COMBINED POWER UNIT
ONL
Y]
12VDC power supply ok
TERMINAL BLOCK NO.
Membrane J716 J717 J121 J122 J123 J124 J112 J111 J719 J151 J14 J73 J72 J21-6
POWER BOARD LEDS
– – – – – – – – – – – – – LD2 LD10 LD9 LD7
MICRO CONTROL BOARD LEDS
LD52 LD17 LD19 LD11 LD13 LD18 LD12 LD49 LD48 LD15 LD42 LD1 LD8 LD6 –
N
O
.
011514
State/Sequence No
Fill Mode Sequence – – – T F T F T F P F C F F F F T
011515 Service Motor Up M – – T F T F T F P F C T T T T T
011516 Service Motor Down – M – T F T F T F P F C T F F T T