SHR-5000™ Dok-Lok
®
Owner's Manual
Rite-Hite
®
22 Publication:
AMEN00096 2018-05-30
MAINTENANCE
!
DANGER
When working with electrical or electronic
controls, make sure that power source has been
locked out and tagged according to approved
local electrical codes.
Post safety warnings and barricade work area, at
dock level and approach level, to prevent
unauthorized use of dock position.
WARNING
A safe work place requires all lights and horn to
be working properly. DO NOT use Dok-Lok vehicle
restraint if parts are broken or missing.
CAUTION
When lifting unit use a proper lifting device (crane,
jack). Lifting by hand may cause back injury.
NOTICE
Contact Rite-Hite if loading docks are exposed to
harsh environments (extreme climates, corrosive
chemicals, high usage, etc) More frequent
maintenance may be required
A Planned Maintenance Program (PMP), customized to
your specific operation is available and recommended. For
a PMP, contact your local Rite-Hite representative
NOTE:
If a leveler is installed at the Dok-Lok vehicle
restraint location, it may be necessary to raise the leveler
before performing maintenance
!
DANGER
B
A
When working under dock leveler platform or lip:
1. Install Safe-T-Strut™ with the assistance of
another person.
• Raise leveler until platform reaches its highest
position and lip extends Maintain this position
• (A) Have assistant insert the smaller end of the
Safe-T-Strut™ through hole in the middle of
leveler lip and place strut’s wider open end over
the base located on leveler’s front frame (B)
• Align the holes on the base and Safe-T-Strut™
so leveler may be secured with retaining pin
and safety clip
• Release the pushbutton on powered levelers
allowing the Safe-T-Strut™ to rest on the
underside of lip
NOTE:
If you are unable to install the
maintenance support, contact your Rite-Hite
Service Representative or Rite-Hite Customer
Service at 1-414-355-2600
2. Lockout and tag power supply.
• Turn off power to control box
• Lock out and tag the main power source
• Barricade leveler at dock and approach levels
to prevent unauthorized use
Safe-T-Strut™ removal:
• Have an assistant raise leveler to its highest
position with lip fully extended
• Release safety clip and remove retaining pin
• Lift the support off base
• Return Safe-T-Strut™ to it's storage position
