Riso ME 6350, Руководство пользователя

Страница: 39 / 306

Basic Operations
Preparing to Print
39
Note:
• Custom size paper must be registered on the
Admin. Screen before use.
) p.204
Failure to do so may create an incomplete master.
4
Select the paper feed pressure.
NORMAL ( ): For standard or thin paper
CARD ( ): For thick or smooth-surface paper
Note:
• The setting condition of the paper feed pressure
is displayed at the top of the [Paper] button on
the Basic Screen.
5
Check the Basic Screen.
1)
Select a mode.
2)
Touch [MasterMake] on the Operation
Selection Screen.
The Master Making Basic Screen appears.
Note:
• The paper size is automatically detected. When
the size display shows “Custom” even if standard-
sized paper has been set, the Feed Tray Paper
Guides are not properly set against the paper.
Make sure that the Feed Tray Paper Guides fit
tightly against the paper.
) p.71
Adding or Replacing Paper
When you add paper or replace with paper of a different
size at the time of printing, press the Feed Tray Ascent /
Descent Button to lower the Paper Feed Tray.
• The Paper Feed Tray is lowered while you press and
hold the button, and when you release the button, the
tray stops at that position.
• When the tray runs out of paper or you remove all
papers, the tray is automatically lowered to the bot-
tom.
• After paper has been replenished, the Paper Feed
Tray automatically rises when you press the Key
on the Control Panel.
Important!:
• When changing to a different paper size, remember
to readjust the Receiving Tray Paper Guides and
Paper Stopper.
• When changing to a different quality paper, remem-
ber to adjust the Paper Feed Pressure Adjustment
Lever.
Note:
• When the Paper Feed Tray has been lowered to the
bottom, if you press this button after paper has been
replenished, the Paper Feed Tray rises.
Closing the Paper Feed Tray
Before closing the Paper Feed Tray, remove the paper
and widen the Feed Tray Paper Guides to the limits.
Then close the Paper Feed Tray.
Feed Tray Ascent /
Descent Button