Risco RWX34S, Руководство по установке

Страница: 6 / 72

5
IMPORTANT:
Never try to avoid false alarms by disabling the detector.
♦
In damp or very humid areas or near bathrooms with showers. Moisture in humid
air can enter the sensing chamber, and then turns into droplets upon cooling,
which can cause false smoke alarms.
♦
In very dusty or dirty areas, dirt and dust can build up on the detector's sensing
chamber, to make it overly sensitive.
♦
Additionally, dust or dirt can block openings to the sensing chamber and keep the
detector from sensing smoke.
INSTALLATION
The smoke and heat detector is to be mounted on the ceiling or on the wall, if
necessary. Since the smoke and heat detector is a single-station type, it cannot be
linked to other detectors.
WARNING:
Do not connect the smoke and heat detectors to any other alarm or auxiliary
device. Connecting anything else to this detector will prevent it from working
properly.
Read the “Where to install your smoke and heat detector” and “Where not to install
your smoke and heat detectors
” sections in this manual before installing.
To install the detector (see Figures 7 & 8 )
1. Select the installation location.
2. Remove the locking pin securing the mounting bracket to the unit (see Figure 7).
3. Remove the mounting bracket from the unit by rotating it counterclockwise.
4. Use the bracket as a template for marking the mounting holes.
5. Using an appropriate drill, drill two holes at the marks and insert anchors.
6. Using screws (supplied) attach the bracket to the wall as shown in Figure 7.
Figure 7: Smoke and heat detector installation