Rinnai MC502S, Руководство по эксплуатации и установке, Страница: 5 / 18

Rinnai New Zealand 3 Operation Manual
USING WIRELESS CONTROLLERS
ABOUT THE WIRELESS CONTROLLER
HOW TO USE WIRELESS CONTROLLERS
TURNING ON THE WIRELESS CONTROLLER
When the controller is switched off only the battery status and
communications indicators are displayed
on the digital monitor.
To turn on the controller, press the On/Off button once. The
communications indicator will briefly illuminate to confirm that a
signal has been sent to the transceiver connected to the water heater.
The Transfer indicator and the digits of the Water Temperature
indicator will illuminate to indicate that the water heater is ready to supply
hot water once a hot water tap is opened.
ADJUSTING TEMPERATURE
Simply press the 'hot water temp' or buttons until the required
temperature is displayed on the digital monitor.
To operate the water heater, open any hot water tap. This will
automatically light the burner, providing hot water. The ‘In Use’ indicator
will illuminate on the water controller.
Once the hot water is running, if the set temperature is either too hot or
cold press the
or buttons until the desired temperature is
reached.
CHECK WATER TEMPERATURE BEFORE USE.
A parent or carer should always check the temperature before a child is placed in
contact with hot water, see page 1.
Whilst hot water outlets are open the set temperature may be lowered. However it
cannot then be raised above 43°C. This is a safety feature.
Transfer On / Off
HOT HOT
COLD COLD
ON! ON!
CAUTION
NOTE