6
Fig. 2b – DINLU Indoor Unit Starting Collar Assembly
2.3 P-Trap
The Indoor Unit incorporates an evaporator drip tray and is supplied with a 20mm Female Pressure Pipe drain spigot, which
is to be connected to the "P" trap.
•
Always install the “P” trap as close to the unit as possible
•
Fill the "P" trap with water during installation before starting unit, to prevent air movement through the drainpipe
•
Ensure trap contains water at all times
•
Adjust the level of the unit to ensure that the condensate drains from the evaporator drip tray (approx. 10 - 15mm
incline from back to front)
Important Note
•
Before installing and commissioning the P-Trap, check to ensure that all joints are sound, including
the preformed U-Bend.
Fig. 3 - “P” TRAP ASSEMBLY
Fig. 4 - “P” TRAP INSTALLATION
Pop
flange
Rivets
(Supplied)
Содержание Brivis DINLU10Z7
Страница 7: ...7 2 4 Outdoor Unit Fig 5 Outdoor Units DONSC10Z71 DONSC13Z71 15Z71 17Z71 ...
Страница 14: ...14 5 4 Wiring Diagrams Fig 11 Typical Indoor Unit Wiring Diagram DINXU DINLU SERIES ...
Страница 16: ...16 Fig 14 Shielded Communication Cable Between Indoor and Outdoor Units ...
Страница 28: ...28 ...