Installation and operating instructions for
Brake HS 165 FHM spring activated
–
hydraulically released
E 09.778e
Issue: 27.05.2021
Version: 3
Drawn: BAHS
Checked: EISF Pages: 28
Page: 16
4
PERIODIC MAINTENANCE
Every two months, check:
-
As a general rule, inspect the entire system for correct operation
-
Check that there is not any leakage
-
Also, check the brake pad gap see chapter 5.3.
Attention!
When the remaining lining thickness reaches 3mm, proceed to pad
exchange as per chapter 5.4. If this rule is not observed, a loss of
breaking force may occur.
Every two years, replace:
-
Oil in the
power pack
(refer to the power pack instructions)
Every five years:
-
Plan complete overhaul of the entire unit (replace worn parts, seals, spring washers, flexible
hoses…)
5
Maintenance
5.1 Manual release: activation
1.
Supply the caliper with a opening pressure and maintain the pressure until point 6.
2.
Remove the 2 retaining segments
14
by their 2 screws
V03
on the cover
21
.
3.
Remove the cover
21
via its 6 Allen screws
V09
.
4.
For an easier handling, it is possible the remove the connector of indicator switches
Fig.5.1. Unlock the connector by insert the screwdriver behind the connector and turn it a
1/4 of a turn counter-clockwise and then insert the screwdriver into the slot at the side to
release the connector.
In ‘ATEX’ execution, it is not possible to remove the connector
Fig. 5.1
Slot
Screwdriver
