5300N™ Operator
2000516_A
© 2007, Rimage Corporation
1
Replace the Bin Present Sensor or the Bin Full Sensor on a Rimage
5300N
Use this procedure to replace the bin present sensor or the bin full sensor on a
Rimage 5300N™
.
The procedures in this document should be performed only by personnel trained and authorized by Rimage. The instructions and
content are written for mechanical and electrical service work assuming the technician has such training and authorization. The
product warranty may become void if equipment or parts are tampered with, misused, neglected, or modified in any respect without
the written consent of Rimage or by technicians who are not authorized or certified by Rimage.
Before you begin
1. Stop or pause all jobs.
2. Power off the
embedded control center
.
3. Power off the
5300N
.
4. Disconnect
the
power cord
.
#
Required tools
:
•
¼” nut driver
•
Torx T8 screwdriver
•
Torx T10 screwdriver
Access the sensors
1. Open
the
front door
.
2. Remove
the
nuts
(Qty. 2) securing the sensor bracket.
3. Remove
the
sensor bracket
and
sensors
.
4. Disconnect
the
sensor cables
(Qty. 2) from the sensors.
n
Caution! Some cables in this system are latched.
Equipment damage may occur if cables are not
disconnected appropriately.
Sensor Bracket
and Sensors
Sensor Cables
