Rikon Power Tools 31-120, Руководство оператора

Страница: 10 / 16

INSTRUCTIONS
Page 10
Intended Use
Battery-operated drills with different evels of
speed and torque are suitable for medium duty
tasks such as drilling, driving screws and other
fasteners.
Unpacking Your Cordless Drill
• Carefully unpack and inspect your product. Fully
familiarise yourself with all its features and
functions.
• Ensure all parts of the product are present and
in good condition. If any parts are missing or
damaged, have such parts replaced before
attempting to use this product.
Before Use
IMPORTANT: Your cordless drill’s battery comes
partly charged. It is recommended that you fully
charge the battery before using the tool for the
first time. It is also recommended that you fully
drain then fully charge the battery for a further 2
times to condition the battery, ensuring optimal
usage is achieved for the duration of the battery
life.
Charging the Battery
ONLY use this charger to
charge the supplied battery or additional
purchased batteries that are specifically designed
for this tool.
The Battery Charger is
designed for indoor use only and MUST NOT be
used in damp or wet conditions.
Failure to follow the correct
procedure when charging batteries will result in
permanent damage.
Note: Fully charging the battery can take 1–3hrs,
depending on how depleted the battery charge
is when inserting the battery into the charger.
Also, it may take longer if the battery has been in
a discharged state for an extended period of time.
1. Plug in the Power Cord.
2. Insert the Battery into the Battery Charger
(it can only fit one way).
3. The Red LED will illuminate, which indicates
charging.
4. The Green LED will illuminate once the
battery is fully charged.
Installing a Driver Bit
Note: Items referenced below and throughout the
manual (A thru L) can be found in the
“OVERVIEW” section of the manual found on
page nine.
1. Turn the Chuck Body (A) of the 3/8″ Keyless
Chuck counter clockwise, open the Chuck Jaws
(B) and insert the bit.
2. Turn the Chuck Body (A) of the 3/8″ Keyless
Chuck clockwise to tighten the Chuck Jaws (B)
onto the bit.
Installing the Battery into Drill
1. Ensure the Battery (L) has adequate charge
(see ‘ Charging the Battery ’).
2. Insert the Battery into the below the Hand Grip
(F & K) (the Battery can only fit one way) until the
Battery locks into place with a faint clicking sound.
3. Your cordless drill is ready for use.
4. Select Forward or Reverse (J) and test the drill
by depressing the Trigger Switch (E).
Removing the Battery
1. Press in and hold the Battery Release clips
on both sides of the Battery (L) then pull down to
remove the Battery.
2. The Battery can now be inserted into the
Battery Charger to charge, if required (see
‘Charging the Battery’) or stored in a cool, dry
place.
Speed Selection
For driving screws and fasteners select ‘1’ on
the Speed Selector Switch (G) for the lower speed
range. A lower speed gear is generally more
suitable for driving screws and fasteners.
For drilling select ‘2’ on the Speed Selector
Switch (G) for the high speed range. A higher
speed gear is for drilling and must not be used for
driving screws and fasteners.
Speed Selection Continued on Page11