Rigol DG800 Series, Руководство пользователя

Страница: 45 / 148

Chapter 2 Front Panel Operations RIGOL
DG800 User's Guide 2-15
Example: To Output Sine
This section mainly introduces how to output Sine waveforms (frequency 20 kHz,
amplitude 2.5 Vpp, offset 500 mV
dc
, start phase 90°) from the [CH1] connector.
1. Select the output channel: Press Output1 on the front panel or tap the
channel output configuration status bar
to select CH1.
2. Select Sine waveforms: Press Menu on the front panel, and then the
waveform selection interface is displayed. Tap Continuous and then select the
"Sine" icon to go to the sine waveform parameter setting interface
automatically.
3. Set frequency: Tap the Freq parameter input field to input 20 with the pop-up
numeric keypad, and then select the unit "kHz". Tap "Ok".
4. Set amplitude: Tap the Ampl parameter input field to input 2.5 with the
pop-up numeric keypad, and then select "Vpp" as the unit. Tap "Ok".
5. Set offset voltage: Tap the Offset parameter input field to input 500 with the
pop-up numeric keypad, and then select "mVdc" as the unit. Tap "Ok".
6. Set start phase: Tap the Phase parameter input field to input 90 with the
pop-up numeric keypad, and then select "°" as the unit. Tap "Ok".
7. Enable channel output: Press Output1 and the backlight turns on. Also, you
can tap the channel output configuration status bar
to enable the
channel output. Then, the channel status is highlighted (i.g. ), and
the Sine signal is output from the [CH1] connector based on the current
configurations.
8. Observe the output waveform: Connect the [CH1] connector of DG800 to
the oscilloscope by using the BNC cable. The waveform is as shown in the figure
below.