1-
Clean the back of your vehicle, unscrew your license
plate, and place it inside the Car Back Carrier’s interior
license plate sleeve (Fig 7).
2-
Load the Car Back Carrier on the ground. The load
capacity of the carrier is 100 lbs.
Assemble The Bottom Pole Frame
The correct attachment of this product is critical and
beyond the control of Rightline Gear. The safe use
and long life of this product depends entirely on
your good judgment and following these directions.
Fig 1
Fig 2
1-
Run (2) of the poles through the pole guides into the
sewn pole pockets (Fig 2).
3-
Run the remaining (2)
poles through the hook-&-
loop pole pockets, through
the pole guides and into
the pole junctions (Fig 4).
4-
Make sure all of the pole frame segments are firmly
locked together (Fig 5).
5-
Close the hook-&-loop pole pockets (Fig 6).
Sewn
Pole
Pockets
Hook-
&-Loop
Pole
Pockets
Pole Guides
Pole Guides
Cross Pole
Assembly
Fig 5
Fig 6
Fig 7
Pack The Carrier
Car Back Carrier Set Up Guide 100B90
www.rightlinegear.com/setup.html
Set Up
Video:
SAFETY NOTES:
• Emergency access to the the vehicle’s rear hatch door
will be extremely limited while using the Car Back
Carrier.
• The vehicle’s automatic rear window, rear windshield
wiper, and back up camera may not be operable
while using the Car Back Carrier.
• Keep the Car Back Carrier and its straps away from
the vehicle’s hot exhaust system.
• Don’t exceed the load rating of your vehicle’s attach-
ment points. The side straps can be routed around ve-
hicle rear fairings if necessary.
Cross
Pole
Assembly
2-
Slide the cross pole assembly onto the (2) pole ends of
(Fig 3).
Fig 8
2-
Pull the (2) strap ends tightly to tension the strap, close
the door over the strap, and let the (2) strap ends hang
down (Fig 9).
3-
After attaching the Car Back Carrier to the vehicle (see
“Attach The Car Back Carrier-...”), adjust the belt strap to
the correct length/tension by sliding the tri-glide. Buckle
the belt strap around the middle of the Carrier (Fig 10).
Attach The Belt Strap
Fig 9
Tri-glide
Buckle
Fig 10
1-
Run the belt strap around the inside of the vehicle’s
rear hatch door (Fig 9). Make sure the strap is not
twisted.
Fig 3
Fig 4
3-
Close the Carrier by bringing the (2) zipper pulls
together (Fig 8).
4-
Fold the zipper flap down to secure the hook-&-loop
closures (Fig 8). Make sure the hook-&-loop closures on the
zipper flap completely overlap those on the carrier. If it is
difficult to secure the closures, the carrier is over packed.
NOTE: THE BELT STRAP IS OPTIONAL IF YOU ATTACH
THE BOTTOM STRAPS TO YOUR VEHICLE (SEE “ATTACH
THE BOTTOM STRAPS”).
Pole
Guides
Sewn
Pole
Pockets
Hook-
&-Loop
Pole
Pockets
Pole
Guides
Pole
Junctions
Pole
Junctions
Zipper Flap
Hook-
&-Loop
Closures
