RF602 [Revision 1.2.0] 28.01.2019
Laser Triangulation Sensors. RF602 Series
27
13.8. Setting and saving parameters of the sensor
13.8.1. Setting parameters
Setting of parameters for all interfaces can be done using the respective tabs on the
Interfaces configuration parameters
panel:
RS232/RS485
Analog outputs
Setting of all configuration parameters of the sensor is possible with the help of the
respective panel (
Sensor configuration parameters
):
13.8.2. Automatic data stream mode after power switch on
By default, after the power supply is switched on, the sensor is waiting for the
request result command. To get a continuous data stream after switching on the power
supply, tick the
Auto stream
box. Save parameters (see below). Now with any subsequent
activation of the sensor it will work in the data stream mode.
13.8.3. Saving parameters
·
All parameters are applied immediately after setting.
·
Perform testing of the sensor operation with new parameters.
·
To store new parameters in nonvolatile memory, execute
File > Write to flash
.
Now, with any subsequent activation of the sensor it will work in the configuration
you have selected.
