Riello RS 25/E BLU Series, Инструкции по установке, использованию и обслуживанию

Страница: 53 / 76

51 20068118
GB
Maintenance
7.2.3 Measuring the ionisation current
The burner is fitted with an ionisation system to check that a flame
is present.
The minimum current for control box operation is 4 μ A. The Op-
erator Panel visualises “30%” (see
"Parameter list"
at page 44,
parameter no. 954).
The burner provides a much higher current, so controls are not
normally required.
However, if it is necessary to measure the ionisation current, dis-
connect the plug-socket on the ionisation probe cable and insert
a direct current microammeter with a base scale of 100
μ A - see
Fig. 38.
7.2.4 Checking the air and gas pressure on the
combustion head
To carry out this operation a pressure gauge must be used to
mesure the air and gas pressure at the combustion head, as
shown in Fig. 39.
WARNING
Carefully check the polarities!
D8090
Fig. 38
D8089
Checking
air pressure
Checking
gas pressure
Fig. 39