Riello P 300 P/G, Инструкции по установке, использованию и обслуживанию

Страница: 20 / 56

20170350 18 GB
Installation
6.10 Nozzle installation
The burner complies with the emission requirements of the EN
267 standard. In order to guarantee that emissions do not vary,
recommended and/or alternative nozzles specified by Riello in
the Instruction and warning booklet should be used. 6.10.1 Nozzle selection
If you want a delivery somewhere between the two values shown
in the diagram (Fig. 16), select a nozzle with a higher flow rate.
The reduction in the flow rate is obtained with the pressure
variator.
AVAILABLE NOZZLES
Tab. H
NOZZLES RECOMMENDED:
– Fluidics, type N1 (without interception rod)
– Fluidics, type W2 (with interception rod)
– Bergonzo, type B3 or B5 (with interception rod)
NOTE:
It is possible to fit also nozzles without interception rod
(Fluidics N1): in this case there will be no anti-dripping
feature on the spray holder.
ATTENTION
It is advisable to replace the nozzle once a year
during periodical maintenance.
CAUTION
The use of nozzles other than those specified by
Riello S.p.A. and inadequate regular maintenance
may result into emission limits non-conforming to
the values set forth by the regulations in force, and
in extremely serious cases, into potential hazards
to people and objects.
The manufacturing Company shall not be liable
for any such damage arising from non-
observance of the requirements contained in this
manual.
Bergonzo Fluidics
kg/h kg/h
PRESS 300 P/G
70 70
80 80
90 90
100 100
125 115
150 130
175 145
200 160
225 180
250 200
275 225
300 250
325 275
- 300
- 330
PRE
SS 450
P/G
70 70
80 80
90 90
100 100
125 115
150 130
175 145
200 160
225 180
250 200
275 225
300 250
325 275
350 300
375 330
400 360
425 400
450 450