Riello UPS Sentinel RT 10000 VA ER, Руководство пользователя

Страница: 25 / 42

25
USE
C
ONNECTIONS AND SWITCHING ON FOR THE FIRST TIME
1) Make sure the mains wire and breakers in the building are enough for the rated capacity of UPS to avoid the
hazards of electric shock or fire.
2) Close the mains switch in the building after installation.
3) After a few moments, the UPS will switch on, the display will light up. A few seconds later, the UPS will enter to
Bypass mode. In Bypass mode, the load is not protected by UPS. To protect your precious devices, you should
turn on the UPS.
4)
Check which operating mode is set on the display and, if necessary, see the “
UPS Configuration
” section to set
the required mode. For advanced UPS configurations execute the software ViewPower which can be downloaded
from the web site
www.rielloupsamerica.com/download_categories.
S
WITCHING ON FROM THE MAINS
1)
Press the “ON” button for 1 second. After pressing it, all the icons on the display light up for 1 second and the
UPS beeps.
A few seconds later, the UPS will enter to Online mode.
2) Switch on the equipment connected to the UPS.
When switching on for the first time only: after 30 seconds, check that the UPS is operating correctly:
1) Simulate a blackout by disconnecting power to the UPS.
2) The load must continue to be powered, the icon on the display must light up and there must be a beep
every 4 seconds.
3) When power is reconnected, the UPS must go back to operating from the mains.
S
WITCHING ON FROM THE BATTERY
1)
Press the “OFF/Enter” button to set up the power supply for the UPS, UPS will enter to power on mode. After
initialization UPS will enter to No Output mode. then to turn on the UPS, and the buzzer will beep once.
2) Press
and hold the “ON/Mute” button for 3 seconds. All the icons on the display light up for 1 second.
3) Switch on the equipment connected to the UPS.
S
WITCHING OFF THE
UPS
Turn off the UPS with utility power supply in AC mode
1)
Turn off the inverter of the UPS by pressing “
OFF/Enter
” button for at least 2s, and then the buzzer will beep
once. The UPS will turn into Bypass mode.
NOTE 1 : If the UPS has been set to enable the bypass output, it will bypass voltage from utility power to output
terminal even though you have turned off the UPS.
NOTE 2: After turning off the UPS, please be aware that the UPS is working at Bypass mode and there is risk of
power loss for connected devices.
2) In Bypass mode, output voltage of the UPS is still present. In order to cut off the output, switch off the input
breaker. A few seconds later, there is no display shown on the display panel and UPS is complete off.
T
URN OFF THE
UPS
IN
B
ATTERY MODE
1)
Turn off the UPS by pressing “
OFF/Enter
” button for at least 2 seconds, and then the buzzer will beep once.
2) Then UPS will cut off output. About 10 seconds later, UPS would shut down completely.