2.3 Rear view
2.4 Control elements and connectors
The BP-2002 is a 2-channel beltpack and therefore has two talk keys and two volume controls. The talk keys are
labelled “I” and “II“. The volume controls are allocated to the relevant talk keys and channels.
The call light key is marked with the letter “L“ and also located at the front of the unit.
To activate the S-CALL, there is a key marked “S” just underneath the volume control on the right-hand side of the unit.
On the right, next to the buttons are channel indicator LEDs. They tell you whether a particular talk key is activated or
not.
The call light indicator is located on the top of the housing.
On the underside of the unit, you will find the XLR connectors for connecting and looping through the intercom line (3-
pin), as well as a 4-pin XLR for the headset.
On the back of the unit are two sidetone trimmers, which are allocated to the two channels, as well as a belt clip.
2.5 Connecting the beltpack to a Riedel Party Line (RPL)
The beltpack is a portable headset station powered through the intercom wiring using the PS-2002 or PS-2004 power
supply.
The beltpack is connected to the party line via a 3-pin XLR plug and is ready for use immediately. The headset is
connected via the 4-pin XLR male headset connector.
RIEDEL RPL_EN_BP-2002e-Rev2.1.doc: 2 12.12.2002 11:29
Page 4 of 11
Röttgen 8, D-42109 Wuppertal,
Alterations reserved
Tel. +49 (0) 202 / 270 370
