Riedel Bolero, Руководство пользователя

Страница: 30 / 84

30
Bolero User Manual A20
2.4.9.2 Antenna NFC
This registration mode allows registering a Beltpack at an already registered Antenna via NFC.
Following steps are necessary to register a Beltpack via Antenna-NFC contact point (
) to a Bolero Net:
·
At first the ' Registration Method (NFC) ' must be activated. This can be done in two ways:
a) Via the Antennas Web-Interface
(see chapter
'Bolero Antenna > Features in Detail > Registration' ).
b) Via another Beltpack that is already registered in the Net:
Menu '
Admin > Registration Mode > Antenna NFC > On
'.
·
The Beltpacks to be registered have to be turned on, no other special setting or user intervention is required.
·
Just hold the NFC contact point of the Beltpacks close to the NFC contact point of any Antenna. The Beltpacks will be
registered to the same net that the antenna belongs to.
·
After registration, the Beltpacks will immediately connect to the Bolero net.
·
This setting is system wide and stays active until disabled or the registration timeout runs out (timeout
is the same as for OTA registration).
·
All Antenna-NFCs are switched to registration mode.
·
The Beltpack-NFCs of connected Beltpacks are NOT switched to registration mode.
2.4.9.3 Beltpack NFC
This registration mode allows registering a Beltpack at an already registered Beltpack via NFC.
Following steps are necessary to register a Beltpack via Beltpack-NFC contact point (
) to a Bolero Net:
At first the Registration Method '
Local Beltpack NFC'
must be activated at the already registered Beltpack ('Master'-
Beltpack):
·
Push the 'Master'-Beltpack's Menu key for >3 seconds (long key press).
·
Navigate to the '
Admin
' menu.
·
Enter the ' Admin PIN ' of the net.
·
Select '
Registration Mode
' > '
Local Beltpack NFC
'.
Figure 19: Registration Mode 'Local Beltpack NFC'
·
The Beltpacks to be registered have to be turned on, no other special setting or user intervention is required.
·
Just hold the NFC contact point of other Beltpacks close to the NFC contact point of the 'Master'-Beltpack. These
Beltpacks will be registered to the same net that the 'Master'-Beltpack belongs to.
·
After registration, the Beltpacks will immediately connect to the Bolero net.
·
The 'Master'-Beltpack stays in the registration mode until the user leaves the menu or the 'Master'-
Beltpack is disconnected (there is no timeout).