4.8 Cable drum onto RW45\240/400L motor gearbox
Installation option K
Install the drum and cable (one or two) onto the RW45L or RW240/400L drive-unit. Refer to the
illustration that follows.
In this manual shown illustrations can be different than the components and/or systems. For more
information on item numbers and models refer to the Ridder catalog or website at
Note:
Ridder does not supply steel cables and steel cable clamps.
5. CONNECT INSTRUCTIONS
Only to approved personnel it is permitted to do the connect instructions.
The RW motor gearboxes are applicable for use in an industrial environment where electromagnetic
interference can have an effect. Usually correct installation makes sure that functional operation is
safely possible without problems. Make sure that the connections obey EMC-conformity.
•
When you put the cables, make sure that
water flows away
from the motor gearbox (make loops
if necessary). Refer to §5.2 “Cable glands”.
•
Make sure that during connection work all phases of all power connections (power supply) are
de-energized
.
M6
ø50 mm
M6 x 80 mm
M6 x 8 mm
ø130 mm
Steel cable
ø6 mm maximum
= ONE
= TWO
HEX 3 mm - 10 Nm
10 Nm
Ridder Drive Systems B.V.
T
+31 (0)341 416 854 -
F
+31 (0)341 416 611 -
I
28